Block Diagram of a Weather Radar Receiver
Block Diagram of a Weather Radar Receiver
High-Dynamic-Range Linear Receiver
In weather radar systems, the objective is not merely to locate targets but also to perform quantitative measurements. This fundamental principle determines the requirements for a weather radar receiver.
The receiver must operate reliably even in the presence of strong echoes from stationary objects. It requires a wide dynamic range, very high sensitivity, and, above all, a transfer characteristic that is as linear and as accurately known as possible. Only then can quantitative estimates of precipitation intensity be derived from the measured echo amplitude.
Dynamic range compression in the receiver is generally permissible, provided that its transfer characteristic is known and can be uniquely inverted throughout the required measurement range. The radar signal processor must be able to reconstruct the original signal amplitude from the compressed signal. In particular, no amplitude information may be lost through limiting or saturation. Therefore, simple STC circuits and logarithmic IF amplifiers followed by demodulation, as used in air-surveillance radar systems, are unsuitable for quantitative weather radar measurements unless the corresponding transfer characteristic is properly compensated.
In the receiver circuit shown, however, a logarithmic amplifier followed by an analog-to-digital converter is used to generate a control signal for a variable attenuator. This control signal is also supplied to the radar signal processor. Consequently, the attenuation applied at any given time is known and can be taken into account when reconstructing the original echo amplitude.
The control system must respond sufficiently quickly and must be accurately synchronized with the corresponding echo signal. In the circuit shown, high-speed flash ADCs with a conversion delay on the order of one nanosecond are used for this purpose. To ensure that a change in attenuation takes effect at the correct instant, the signal in the linear receiver path must be delayed accordingly. This prevents unwanted switching transients and errors in amplitude measurement. Delays of this order can be implemented using coaxial delay lines consisting of a few meters of cable.
Figure 1: Block diagram of a weather radar with a high-dynamic-range linear receiver
The system shown is a coherent radar. All frequencies and timing pulses are derived from the highly stable frequency of a master oscillator and therefore maintain a defined phase relationship with one another. The STALO frequency is generated through multiple stages of frequency multiplication and mixing of the resulting intermediate signals. It is higher than the transmit frequency by the intermediate frequency (IF).
The intermediate frequency is also derived from the master oscillator frequency. The corresponding oscillator is often referred to as the COHO, because it maintains the required phase relationship (coherence) in the receiver path. The transmit frequency is generated by mixing the STALO and COHO frequencies. In the modulator, the transmitted pulse is initially generated at low power as a short section of this continuous-wave signal. The pulse is then amplified and radiated by the antenna at high power. The transmitter output stage uses a multicavity klystron, which provides high peak pulse power with a short transmitted pulse duration.
The pulse repetition frequency can be switched. This change may be accompanied by a corresponding adjustment of the transmitted pulse duration so that the radar operates with a constant duty cycle. However, this requires the receiver bandwidth to be adjustable for different pulse durations.
Different pulse repetition intervals, and therefore different maximum measurement ranges, can be used during a complete volume scan. At very high elevation angles, there is no need to search for clouds all the way up to the ionosphere. At elevation angles of approximately 15 to 20° and above, a shorter measurement range may therefore be sufficient. The required receiving time is then shorter than for measurements at low elevation angles with a long measurement range. As a result, a complete volume scan can be finished in less time.