www.radartutorial.eu www.radartutorial.eu Radar Basics

The Concept of Coherence


stable continuous oscillation as reference
1. PRT
2. PRT
3. PRT
random phase

Figure 1: Origin of coherence, coherent and non-coherent transmitted pulses


stable continuous oscillation as reference
1. PRT
2. PRT
3. PRT
random phase

Figure 1: Origin of coherence, coherent and non-coherent transmitted pulses

What Is a Coherent Radar?

The Concept of Coherence

Coherence describes the phase relationships between transmitted pulses in a pulse radar system. Oscillations and electromagnetic waves are described as coherent when their phase relationships remain constant. In the case of incoherence, these phase relationships are statistically distributed. Whether a radar operates coherently depends largely on the type of transmitter and the availability of a phase reference. Various transmitter systems can be used in a radar, and these may be coherent, partially coherent, or non-coherent.

Non-coherent Radar

One possible transmitter system is the self-oscillating transmitter (Power Oscillator Transmitter, POT). When such a transmitter is switched on and off by a rectangular modulation pulse, it begins to oscillate with a different phase at the start of each transmitted pulse. The initial phase of the oscillation is entirely random.

Remember: Self-oscillating transmitters have a random phase from pulse to pulse and are therefore non-coherent!

Coherent Radar

Another transmitter system is the PAT (Power Amplifier Transmitter). In this system, the transmitter essentially consists of a high-power amplifier and is driven by a highly stable continuous oscillation from a master oscillator, which synchronizes the waveform generator. The master oscillator (coherence oscillator) must provide a phase-stable continuous oscillation. The individual transmitted pulses then consist of sections of this continuous oscillation. Radars in which the phase relationship is this stable are called fully coherent. Modulation of the transmitter's power output stage does not affect the phase of the transmitted pulse.

If the pulse repetition frequency (PRF) is also derived from the frequency of the master oscillator, every transmitted pulse even starts with the same phase. If this oscillator is so stable that the phase of its oscillation does not deviate over hours or even days, the radar remains coherent not only from pulse to pulse, but also from scan to scan – even after the next antenna revolution (or, in the case of satellites, even after the next orbit around the Earth). Deviations would occur if so-called phase noise arises during the generation of the oscillation.

Remember: Low-power master oscillators followed by high-power amplification provide a constant phase relationship between transmitted pulses, resulting in coherence!

Pseudo-coherent Radar

By using a circuit technique, even non-coherent radars can determine the phase of an echo signal. Although the transmitter starts with a random phase, this phase can be preserved as a reference throughout the reception period by means of a controlled damped oscillation. A stable coherence oscillator is forced by the phase of the current transmitted pulse to continue oscillating with that phase. The next transmitted pulse, however, starts with a different, random phase. The phase reference must therefore be established again for each reception period. This method is also called “coherent on receive”, meaning coherence on the receiving side.

External Coherence

In addition to the internal coherence described so far, there are also radars employing external coherence. In these radars, the phase reference is obtained from echoes of passive clutter, such as stationary targets. By comparing the signals with this reference, moving targets can be detected even though the transmitter itself operates non-coherently.

Advantages

At typical aircraft speeds and the wavelengths used in radar, Doppler frequencies are usually within the audio frequency range. Because of the short dwell time of surveillance radars on a target, only a few echoes can be obtained. These correspond to very few oscillation periods of the Doppler frequency to be measured, often only one! This is far too little to measure the frequency directly as an oscillation. The radar must therefore measure the phase change from pulse to pulse to determine the Doppler frequency.

The main advantage of these coherent systems is that even very small phase changes in the echo signal can be detected, allowing the influence of stationary targets to be reduced by exploiting the Doppler effect. Furthermore, the signal-to-noise ratio can be improved through the coherent integration of several echo signals.