What is AGC in receiver?
Automatic Gain Control Methods
Most radar receivers use some means to control the overall gain. This usually involves the gain of one or more IF amplifier stages. Manual gain control by the operator is the simplest method.
In a radar, the following typical amplification controls are used:
- distance-dependent (i.e. time-dependent) amplification control (STC or GTC)
- noise-dependent automatic amplification control (AVR)
- main gain control (manual amplification control)
- logarithmic amplifier
Sensitivity Time Control (STC)
Figure 1: Diagram of the sensitivity time control
In radar receivers, the wide variation in return signal amplitudes make adjustment of the gain difficult. The adjustment of receiver gain for best visibility of nearby target return signals is not the best adjustment for distant target return signals. Circuits used to adjust amplifier gain with time, during a single pulse repetition period, are called STC circuits, or „swept gain attenuator”.
Sensitivity time-control circuits apply a bias voltage that varies with time to the IF amplifiers to control receiver gain. The Figure shows a typical STC waveform. When the transmitter fires, the STC circuit decreases the receiver gain to zero to prevent the amplification of any leakage energy from the transmitted pulse. At the end of the transmitted pulse, the STC voltage begins to rise, gradually increasing the receiver gain to maximum. In the ideal case the the receiver gain is proportionally to R4. In the practice this course is frequently approached by the arising e function for the store of a condenser.
The STC voltage effect on receiver gain is usually limited to approximately 50 miles. This is because close-in targets are most likely to saturate the receiver; beyond 50 miles, STC has no affect and the receiver operates normally.
Automatic Gain Control (AGC)
Figure 2: automatic gain control block diagram
Figure 2: automatic gain control block diagram
Figure 2: automatic gain control block diagram
Gain control is necessary to adjust the receiver sensitivity for the best reception of signals of widely varying amplitudes. A complex form of automatic gain control (agc) or instantaneous automatic gain control (iagc) is used during normal operation. The simplest type of agc adjusts the IF amplifier bias (and gain) according to the average level of the received signal. With agc, gain is controlled by the largest received signals. When several radar signals are being received simultaneously, the weakest signal may be of greatest interest. Iagc is used more frequently because it adjusts receiver gain for each signal.
The agc circuit is essentially a wide-band, dc amplifier. It instantaneously controls the gain of the IF amplifier as the radar return signal changes in amplitude. The effect of iagc is to allow full amplification of weak signals and to decrease the amplification of strong signals. The range of iagc is limited, however, by the number of IF stages in which gain is controlled. When only one IF stage is controlled, the range of iagc is limited to approximately 20 dB. When more than one IF stage is controlled, iagc range can be increased to approximately 40 dB.
Dynamic Swept Gain
Figure 4: Diagrams of dynamic STC-curves
Local clutter levels dictate the magnitude of swept gain and differing requirements for swept gain are presented as the antenna rotates. Modern systems dynamically measure clutter levels for a large number of cells within the coverage area of the radar. These measurements are slowly adjusted to take account of changing clutter levels and used to set the swept gain attenuator to an appropriate level for the range azimuth cell currently being processed. In most cases, the values used are a variation on the normal static law.
This approach, while simple in principle, can risk reduction of MTI performance at the edges of clutter. This is due to abrupt changes in swept gain law destroying the integrity of the clutter amplitudes. Furthermore if long or compressed pulses are used, amplitude changes can affect the performance.
Swept gain is generally applied to pin diodes, which are biased to provide a reasonably linear characteristic.