www.radartutorial.eu www.radartutorial.eu Radar Basics

Logarithmic Amplifier

Another way to reduce the dynamic range of radar echoes is to use a so-called logarithmic amplifier. It takes its name from the approximately logarithmic shape of its transfer characteristic. A characteristic feature of a logarithmic amplifier is that it provides high gain for weak signals, while stronger signals receive progressively less amplification. This allows even very strong echoes to be processed while maintaining high sensitivity, without the output being clipped by overload of the amplifier as a whole.

IF filter
IF
IF amplifier
Threshold circuits
Video
Ue
Iges
Ra
Ua
I1
I2
I3
I4
I5

Figure 3: Block diagram of a logarithmic amplifier

IF filter
IF
IF amplifier
Threshold circuits
Video
Ue
Iges
Ra
Ua
I1
I2
I3
I4
I5

Figure 3: Block diagram of a logarithmic amplifier

Block diagram: Five IF amplifier stages are connected in cascade after an IF filter. Each stage has an additional output connected to a detector and threshold circuit. The output currents from these circuits are summed through a common load resistor, across which the logarithmically compressed video output voltage is developed.
IF filter
IF
IF amplifier
Threshold circuits
Video
Ue
Iges
Ra
Ua
I1
I2
I3
I4
I5

Figure 3: Block diagram of a logarithmic amplifier

The logarithmic amplifier consists of several cascaded IF amplifier stages. The number of stages and their individual gains determine the usable dynamic range. Each stage has an additional signal tap connected to a detector and threshold circuit. By combining the individual output signals, the overall amplifier exhibits an approximately logarithmic transfer characteristic.

As the input amplitude increases, the later amplifier stages reach saturation first, while the earlier stages are still operating in their linear region. The IF signals tapped from the stage outputs are detected. When the corresponding detector voltage exceeds a predefined threshold, the associated threshold circuit provides a current contribution. Stages that have already reached their limiting level supply approximately constant current contributions, while additional stages begin to contribute as the input amplitude increases. The individual currents add up to the total current Iges. This produces an output voltage Ua across the common load resistor Ra, which varies approximately with the logarithm of the input signal amplitude. Since the IF signals are also demodulated in this process, the output is a video signal rather than an IF signal that preserves the original phase information.