www.radartutorial.eu www.radartutorial.eu Radar Basics

Noise in Cascaded Amplifiers

Amplifiers are often connected in series to achieve a higher overall gain. However, every amplifier circuit generates its own internal noise. The most common sources are semiconductor noise, thermal noise in resistive components, and current noise caused by the movement of electric charge carriers.

G1
N1
G2
N2
G3
N3
Gn-1
Nn-1
Gn
Nn

Figure 1: Noise in cascaded amplifiers
(N = noise power; G = power gain)

G1
N1
G2
N2
G3
N3
Gn-1
Nn-1
Gn
Nn

Figure 1: Noise in cascaded amplifiers
(N = noise power; G = power gain)

A series of amplifier stages, each with a power gain G and an internally generated noise power N.
G1
N1
G2
N2
G3
N3
Gn-1
Nn-1
Gn
Nn

Figure 1: Noise in cascaded amplifiers
(N = noise power; G = power gain)

The internal noise generated by one amplifier stage becomes an input signal to the following stage and is amplified just like the desired signal. Here, N denotes the internally generated noise power referred to the output of each amplifier stage, while G denotes its linear power gain. Consequently, the noise at the output of the second stage consists of the noise generated by that stage and the amplified noise from the first stage (which together constitute the input noise NE3 of the third stage):

NE3 = N2 + G2·N1

The noise at the output of the third amplifier stage therefore consists of the following components:

NE4 = N3 + G3·(N2 + G2·N1)

This sequence can be continued to obtain the equation for the total internally generated output noise power of the amplifier chain:

NGes = Nn + Gn·{Nn-1 + Gn-1·[   ...   N3 + G3·(N2 + G2·N1)]}

To obtain the best possible signal-to-noise ratio at the output of the amplifier chain, the following principles should be considered:

  1. Noise generated by the first amplifier stages has the greatest influence. Therefore, these initial stages should have the lowest possible internal noise.
  2. Because the last stage also amplifies the noise generated by all preceding stages, its contribution to the total gain should be kept as small as practical.

This means that the first amplifier stage must meet the most demanding requirements. It should provide the highest practical gain while generating as little internal noise as possible. In receiver design, this input stage is also called a low-noise amplifier (LNA, Low Noise Amplifier), and it must be capable of processing the highest frequencies of the incoming signals.