www.radartutorial.eu www.radartutorial.eu Radar Basics

Polarimetric Radar

Table of contents
« Polarimetric Radar »
  1. Block Diagram
  2. Operating Modes with Dual Polarization
  3. Polarimetric Radar Products

Figure 1: Stylized measurement processes of polarimetric radars

Figure 1: Stylized measurement processes of polarimetric radars

Stylized measurement processes of polarimetric radars,
© 2015 Christian Wolff www.radartutorial.eu

Figure 1: Stylized measurement processes of polarimetric radars

Figure 2: A falling raindrop displaces the air. On its sides the flow lines are compressed and a pulling force is created (similar to the aerodynamics on an airplane wing). This pulls the drop into a wider width. The larger the drop, the stronger this compression and the stronger this force.

Figure 2: A falling raindrop displaces the air. On its sides the flow lines are compressed and a pulling force is created (similar to the aerodynamics on an airplane wing). This pulls the drop into a wider width. The larger the drop, the stronger this compression and the stronger this force.

Polarimetric Radar

The use of dual polarization is one way to distinguish between hail and raindrops. The radar transmits and receives linearly polarized RF signals and switches rapidly between horizontal and vertical polarization, either alternating between individual transmit pulses or between groups of pulses. Modern dual polarized radars usually transmit both polarization directions simultaneously.

Block Diagram of a Polarimetric Radar

In this example of a polarimetric radar, a −3 dB coupler divides the transmitter power into two equal parts. Both parts are radiated simultaneously with different polarizations by a dual-polarized feed horn.

Figure 3: Block diagram of a polarimetric radar

Figure 3: Block diagram of a polarimetric radar

Figure 3: Block diagram of a polarimetric radar
(interactive picture)

For reflectivity measurements, a switch also allows transmission in only one polarization plane, in which case the full transmitter power is available in that channel. Even then, echo signals are received in both polarization planes and evaluated by the signal processor.

This is useful because the polarization direction of an electromagnetic wave can change as it passes through a rain area and is subsequently scattered. The change provides additional information about the size and shape of the hydrometeors.

Description of the modules in the block diagram
Dual Polarization Modes

Transmission and reception in different polarizations can be performed either simultaneously or alternately from one pulse repetition period to the next. The choice depends on whether transmitter power is to be divided between two channels and whether two independent receiving channels are available. In general, four dual-polarization operating modes are possible:

In practice, simultaneous transmission and reception have become the preferred approach. The hardware requirements (twice the transmitter power to maintain the same power-limited range, and two independent receivers) are readily achievable, while simultaneous processing saves measurement time. This operating mode is also known as:

Alternating between polarizations requires more measurement time and is therefore less common today. Some manufacturers nevertheless use the marketing term Quad-Pol to indicate that a radar can support all four dual-polarization operating modes.

Figure 4: The larger the raindrops, the flatter their shape, the larger the ZDR

Figure 4: The larger the raindrops, the flatter their shape, the larger the ZDR

Polarimetric Radar Products

Visual representations of measurement results are called radar products.

Differential Reflectivity (ZDR)

The horizontally and vertically polarized echo signals are used to determine the reflectivities ZH and ZV. Their ratio gives the differential reflectivity ZDR. In moderate to heavy rain, larger raindrops become flattened during free fall, taking the shape of oblate spheroids. Consequently, the horizontally polarized echo is stronger.

Formula for differential reflectivity

The dielectric factor of solid ice relevant to radar backscattering is only about 20% of the corresponding value for water. Particle shape therefore has less influence on the reflectivity of dry hail than on that of liquid raindrops. Hailstones tumble as they fall, so ZDR is often close to zero. High horizontal reflectivity ZH together with a low ZDR value may therefore indicate hail. Negative ZDR values (in decibels) may also occur, but are not conclusive evidence of hail on their own.

Polarimetric radar can provide information about the size of raindrops. Larger raindrops become more flattened during free fall than smaller ones, changing the ratio of the echoes in the two polarizations. Together with the measured reflectivity, ZDR gives an indication of the drop size distribution. It does not, however, directly determine the size of each individual drop.

Linear Depolarization Ratio (LDR)

When the radar transmits horizontally polarized energy, the receiver for the vertically polarized channel remains active. It receives the portion of the horizontally polarized radiation that has been rotated into the vertical plane (depolarized). The logarithmic ratio between the cross-polarized echo (horizontal transmission and vertical reception) and the co-polarized echo (horizontal transmission and reception) is called the linear depolarization ratio (LDR).

For spherical particles, LDR theoretically approaches –∞; in practice, values as low as approximately – 40 dB can be measured.

No polarimetric radar known to the author can directly measure the size of an individual hailstone. It can identify indications of hail from the differential reflectivity ZDR and the measured phase differences between the horizontally and vertically polarized received signals. By comparing reflectivities previously measured by that radar with observations of actual precipitation types and amounts, it is possible to estimate the precipitation amount with some confidence and assess whether hail is present. However, this method cannot directly determine whether there are many small hailstones or a few large ones.

Differential Phase (φDP)

The differential phase shift, or simply differential phase φDP, measures the difference between the phase changes of horizontally and vertically polarized radar signals over the outward and return paths. It is defined as:

φDP = φHH − φVV

(2)

When horizontally and vertically polarized radar waves pass through an area of precipitation, their propagation is delayed by different amounts, depending on the shape and orientation of the hydrometeors. This produces an additional phase difference between the two echoes over the outward and return paths. The differential phase φDP therefore provides information about the precipitation particles.

Variations in the differential phase φDP can also help distinguish meteorological echoes from unwanted echoes. However, large local variations alone are not proof that an echo originates from a point target.

Specific Differential Phase (KDP)

The differential phase φDP accumulates along a radar radial because the phase changes along the entire propagation path contribute to the measured value. For this reason, the specific differential phase KDP is calculated. It describes the change in φDP per unit distance and can be expressed as a phase gradient:

(3)

Like ZDR, KDP depends on the size, shape, and orientation of hydrometeors. It is therefore another useful quantity for distinguishing raindrops from hail and graupel.

Co-polar Cross-correlation Coefficient (ρHV)

The co-polar cross-correlation coefficient ρHV is a statistical correlation between the horizontally and vertically polarized echo signals. It measures the similarity between the two echoes and can indicate regions containing a mixture of precipitation types, such as rain and snow.

The calculation uses the mean scattering amplitudes measured within the pulse volume (SHH, SVV) over two or more pulse repetition periods.
ρHV is calculated as follows:

(4)

(The expression S*HH denotes the complex conjugate signal.)