www.radartutorial.eu www.radartutorial.eu Radar Basics

Satellite Altimetry

area illuminated
by the pulse
received energy

Figure 1: Interaction of the pulse of duration τ with a smooth surface.

area illuminated
by the pulse
received energy

Figure 1: Interaction of the pulse of duration τ with a smooth surface.

Satellite Altimetry

A satellite-based radar altimeter needs to measure the distance accurately, but only for an essentially planar surface, oriented orthogonally to the radar’s line-of-sight. Hence, ocean-viewing altimeters have a small range window whose position tracks the delay and strength of the surface reflection. The altimeter measures the round trip time of the electromagnetic waves and their phase shift. As electromagnetic waves travel through the atmosphere, they can be decelerated by water vapor or ionization. Once these phenomena are corrected, the final range R is estimated within an accuracy of ± 2 cm. However, the transmitted pulse is subject to major changes during the reflection. This is caused by the curvature of the resolution cell by a few meters so that the transmitted pulse cannot be reflected uniformly over a nominally level flat surface.

After a running time of R/c0, the reflecting surface is arrived by the pulse at a point. The transmitted pulse reflects first from an area that may be much smaller than the footprint illuminated by the antenna pattern. During the compressed pulse length τ the area illuminated by the pulse rises to a circular area. After that a hole arises in the middle of the circular area: the reflection is finished in the middle but on the edges of the antenna pattern (they have due to the angle a greater slant range) the transmitted pulse is not yet arrived at the Earth’s surface. The illuminated area looks like a hoop. As long as the reflective surface increases, so does the received power – this is the leading edge of the received pulse (this happens up to the time (R/c0) + τ. If the hole arises, then the reflective surface is relatively constant – that is the pulse top.

In the figure, the ratio between the compressed pulse length and the diameter of the hoop is not drawn to scale. For an altimeter in a 1 000-km orbit a half-power beamwidth of 0.32 degrees would lead to a footprint of diameter 2.8 km. A compressed pulse length of about 3 nanoseconds leads to a reflected pulse with a length of more than 26 nanoseconds therefore. In practice, the Earth’s or the sea's surface is rough rather than flat. The pulse edges are even more flattened further. The measurement is therefore used exactly the point at which the rising edge of the echo signal enters the pulse top (R/c0 + τ).

As a result of the random distribution of the ocean wave facets at any instant, each return signal is very noisy but averaging up to 1 000 successive echo pulses can reduce this. The ocean’s surface has a significant wave height of less than 20 m. Radar backscatter is primarily specular, spanning up to 20 dB. The altimeter can average out the effect of the ocean waves. This parameter is called a Significant Wave Height (SWH).