Detector (automatic target recognition)
Figure 1: Part of the block diagram (information flow)
Detector
I-channel
Q-channel
algorithm
Detector
Extractor
Processor
Combiner
SSR and PSR
Sources
frequency
video
video
(real time)
Figure 1: Part of the block diagram (information flow)
Detector (automatic target recognition)
The receiver’s output contains a mixture of target signals, noise, clutter, and jamming signals. Even after suppressing fixed targets, there are still traces of weather and fixed target interference, and the target pulses experience various amplitude fluctuations. The automatic target character recognition needs to identify the target’s location amidst the noise and clutter while maintaining a low but constant false alarm rate (CFAR).
Before reaching the I&Q phase detector, the echo signals are still present in the intermediate frequency (IF) as a signal. Once they pass through the phase detector, the I and Q components are individually processed, resulting in a bipolar video signal. At this stage, MTI processing is necessary. After the MTI processing, both components are merged to form a unipolar video using a trigonometric approximation to the Pythagorean equation or by employing the CORDIC algorithm. This is also a suitable point to digitize the data, although it can also be done directly after the phase detector in other radar sets or directly after the antenna in digital receivers.
The radar detector compares the signals with different threshold values to determine the false alarm rate and the probability of detection. If the echo pulses exceed a certain threshold, the pulse is sent in its larger size, known as a “hit”, and contains information about the signal amplitude and any additional information like which filter was applied. All processes within the radar set are still running in (approximately) real-time at this point. The pulses do not yet have direct coordinates and are related to a pulse period. A single target can generate a large number of hits depending on the dwell time and the number of hits per scan. The target distance is encoded in the delay time compared to the transmission pulse, and the bearing angle is the current position of the antenna.
The real-time reference is lost only from the plot processor onwards. This means that the reference to the delay time to the transmission pulse and the actual position of the antenna is also lost. From now on, the distance calculated from the delay time, the bearing angle, and the time of detection must be associated with the target sign as data.
Detector
I-channel
Q-channel
algorithm
Detector
Extractor
Processor
Combiner
SSR and PSR
Sources
frequency
video
video
(real time)
Figure 1: Part of the block diagram (information flow)