www.radartutorial.eu www.radartutorial.eu Radar Basics

Time-Bandwidth Product

Comparison of the time-bandwidth products of an unmodulated, a phase-coded, and a frequency-modulated radar pulse.
unmodulated pulse
binary phase-coded
linear frequency modulation

Figure 1: Time-bandwidth products of different transmitted radar pulses

Comparison of the time-bandwidth products of an unmodulated, a phase-coded, and a frequency-modulated radar pulse.
unmodulated pulse
binary phase-coded
linear frequency modulation

Figure 1: Time-bandwidth products of different transmitted radar pulses

Time-Bandwidth Product

The product of the transmitted pulse duration T and the signal bandwidth BW, which must also be accommodated by the receiver, is known as the time-bandwidth product (TBP or TBWP). For a fixed transmitted waveform, this product is constant. Modern radars, however, may employ different waveforms with different time-bandwidth products. The time-bandwidth product is an important parameter in radar design and indicates the achievable pulse compression ratio. The selected waveform also affects the levels of the resulting time sidelobes.

The radar receiver bandwidth should be kept as narrow as possible to avoid admitting unnecessary noise and interference. However, it must cover at least the bandwidth required by the selected waveform so that echo signals can be processed with minimal loss. In a pulse compression radar, the signal bandwidth largely determines the duration of the compressed pulse. For an unmodulated pulse, the required bandwidth instead depends on its pulse duration. The shorter the compressed or unmodulated pulse, the greater the required bandwidth and the better the achievable range resolution.

For a radar employing simple pulse modulation with a transmitted pulse duration of T, the required bandwidth is approximately 1/T. The time-bandwidth product is therefore approximately T/T = 1. For this waveform, range resolution depends directly on the transmitted pulse duration T.

With binary phase-coded modulation, the signal bandwidth depends on the duration τ of the individual code elements (chips). It is approximately 1/τ. The compressed pulse duration is also on the order of the chip duration. Thus, the time-bandwidth product is approximately TBP = T/τ. If the radar uses a Barker code, the maximum length among the known binary Barker codes is 13. A time-bandwidth product of approximately 13 can therefore be achieved. In this example, the time-bandwidth product approximately equals the achievable pulse compression ratio.

Radars employing frequency-modulated transmitted pulses can achieve time-bandwidth products ranging from several hundred to 10,000 or more. For a linearly frequency-modulated pulse, the signal bandwidth is determined by the difference between the upper frequency f2 and the lower frequency f1, giving BW = Δf = f2 - f1. The time-bandwidth product is therefore TBP = T·Δf. When the radar pulse duration is changed, the time-bandwidth product usually changes as well. Nevertheless, different pulse durations can produce the same time-bandwidth product if the signal bandwidth is adjusted accordingly.

For example, the air defense radar RRP-117  employs two transmit frequencies, each using a linearly frequency-modulated pulse waveform. With a transmitted pulse duration of 100 µs (short-range mode) and a signal bandwidth of 750 kHz, the resulting time-bandwidth product is 75. From this signal bandwidth, a theoretical range resolution of approximately 200 m can be estimated. However, the range resolution actually achieved depends on additional factors that are not accounted for in this simplified calculation.

Another example of an exceptionally high time-bandwidth product is the strategic radar AN/FPS-108 “Cobra Dane” , with a reported TBP of 200,000.

The Gaussian pulse occupies a special position. For Gaussian-shaped signals, a theoretical time-bandwidth product of TBP = ¼ can be obtained using an appropriate definition of pulse duration and bandwidth. However, the exact numerical value depends on how these quantities are defined. A Gaussian filter produces a smoothly varying pulse waveform without overshoot. In some older radar systems, the receiver bandwidth could be reduced accordingly using a special operating mode (“Limited”). Although this slightly reduced the maximum range achievable in terms of received signal energy, because not all energy components of the echo signal were processed, it also allowed interference outside the narrower receiver passband to be effectively suppressed.