www.radartutorial.eu www.radartutorial.eu Radar Basics

Clutter-Doppler Filter

The clutter-Doppler filter operates in a manner similar to classical pulse-to-pulse cancellation in a pseudo-coherent radar system. However, comparing three pulse repetition intervals requires somewhat more complex mathematical processing. In practice, many different implementations are possible. The objective is to cancel echo signals with constant amplitude and phase. For example, the data from the first pulse repetition interval can be stored with a negative sign. The data from the second and third intervals are each added at half their original amplitude to the negatively stored data from the first interval. An output signal is produced only during the third pulse repetition interval.

Q-data
(or I-data)
weighting
data
CDF-
data
Multiplier
Adder Logic
Multiplexer
Rescaler
Memory
(3rd PRT)
(1st + 2nd PRT)

Figure 1: Block diagram of a clutter-Doppler filter using the “Integrate & Dump” method

Q-data
(or I-data)
weighting
data
CDF-
data
Multiplier
Adder Logic
Multiplexer
Rescaler
Memory
(3rd PRT)
(1st + 2nd PRT)

Figure 1: Block diagram of a clutter-Doppler filter using the “Integrate & Dump” method

weighting
data
CDF-
data
Multiplier
Adder Logic
Multiplexer
Rescaler
Memory
(3rd PRT)
(1st + 2nd PRT)
I&Q Multiplier Adder Logic Multiplexer Memory Rescaler Weighting Data CDF Data

Figure 1: Block diagram of a clutter-Doppler filter using the “Integrate & Dump” method (interactive diagram)

Usually, three pulse repetition intervals are compared, but four intervals can also be used. In this third-order cancellation method, four consecutive pulse repetition intervals are weighted by the factors 1, −3, +3, and −1. This provides stronger suppression not only of stationary targets but also of slowly moving clutter, such as rain clouds driven by the wind. The disadvantage is that echoes from slowly moving targets are also attenuated more strongly. A practical advantage of the circuit shown here is that both the three-pulse and the four-pulse cancellation methods can be implemented using the same hardware. The decisive factor is the software controlling the multiplexer and specifying the weighting coefficients.

Description of the Blocks in the Block Diagram

The following example demonstrates the calculation of the echo signal from a stationary target using the three-pulse cancellation method. The echo from a stationary target has approximately the same amplitude and phase during all three pulse repetition intervals. Therefore, the I&Q data are also approximately equal during these three intervals.

1st PRT:
weighting = 1
2nd PRT:
weighting = -2
3rd PRT:
weighting = 1

Figure 2: Vectors of a stationary target in the clutter-Doppler filter

1st PRT:
weighting = 1
2nd PRT:
weighting = -2
3rd PRT:
weighting = 1

Figure 2: Vectors of a stationary target in the clutter-Doppler filter

As expected, the output signal is a − 2·a + a = 0. Echo signals from targets with zero Doppler frequency are therefore suppressed. In the next example, the amplitude and phase of the individual signals are not identical. The three input signals are added after weighting, producing the CDF data represented here by the green vector.

1st PRT:
weighting = 1
2nd PRT:
weighting = -2
3rd PRT:
weighting = 1

Figure 3: Vectors of a moving target. The green output vector represents the CDF data.

1st PRT:
weighting = 1
2nd PRT:
weighting = -2
3rd PRT:
weighting = 1

Figure 3: Vectors of a moving target. The green output vector represents the CDF data.