WSR-1 to WSR-4
Description of the radar set, tactical-technical characteristics
Figure 1: WSR-1 to WSR-4


| Specifications | ||
|---|---|---|
| WSR-1 … WSR-3 | WSR-4 | |
| frequency: | 3,3 GHz
(S band) | |
| pulse repetition time (PRT): | ||
| pulse repetition frequency (PRF): | ||
| pulsewidth (τ): | 1 or 2 µs | 1 or 4 µs |
| receiving time: | 650 or 325 Hz | 650 or 164 Hz |
| dead time: | ||
| peak power: | 50 kW | |
| average power: | ||
| instrumented range: | > 100 km | |
| range resolution: | ||
| accuracy: | ||
| beamwidth: | 4° | |
| hits per scan: | ||
| antenna rotation: | ||
| MTBCF: | ||
| MTTR: | ||
WSR-1 to WSR-4
The WSR-1, WSR-1a, WSR-3, and WSR-4 (from Weather Surveillance Radar) are early weather radar sets operating in the S band (IEEE designation) or F band (NATO designation), respectively. They are modified AN/APS-2F sets developed by the former US Weather Bureau, the predecessor of today's National Weather Service, and differ mainly in their various display combinations.
WSR-1 and WSR-1a utilized only one PPI scope with an additional A scope. In the WSR-1, they were arranged side by side, while in the WSR-1a, they were stacked on top of each other. Starting with the WSR-3, display on an RHI scope
The antenna is the original symmetrical parabolic antenna with a diameter of 6 feet (≙ 1.8 m). Some of the WSR-4 units are reported to have been upgraded with a larger antenna. The antenna was protected from wind and weather by a fiberglass radome.
All versions used a magnetron transmitter. The WSR-4 was equipped with a traveling wave tube as an RF preamplifier, which significantly improved the sensitivity of the receiver.
Picture gallery of WSR-1 to WSR-4
Source:
- History of Operational Use of Weather Radar by U.S. Weather Services Part I: The Pre-NEXRAD Era