S-264
Description of the radar set, tactical-technical characteristics
Figure 1: S-264
| Specifications | ||
|---|---|---|
| S-264 | S-264A | |
| frequency: | 582 … 606 MHz
(UHF band) | |
| pulse repetition time (PRT): | ||
| pulse repetition frequency (PRF): | 500 … 800 Hz | 260 … 550 Hz |
| pulsewidth (τ): | 2 or 4 µs | 3 or 4 µs |
| receiving time: | ||
| dead time: | ||
| peak power: | 50 kW | 500 kW |
| average power: | ||
| instrumented range: | 110 NMNM (≙ 200 km) |
216 NMNM (≙ 400 km) |
| range resolution: | ||
| accuracy: | ||
| beamwidth: | 2.2° | |
| hits per scan: | ||
| antenna rotation: | 5 or 10 rpm | |
| MTBCF: | ||
| MTTR: | ||
S-264
S-264 was operating in UHF band fully coherent terminal area and en-route surveillance radar. It is a further development of the Marconi S-234.
Type S-264A is essentially the same equipment as Type S-264, but incorporates a multi-cavity, high power klystron based power amplifier wich increased the peak power from 50 kW to approximately 500 kW. Both versions use a staggered pulse repetition frequency. The radar provides a highly efficient and stable MTI due to crystal control througout. The antenna uses a single curved (cylindrical) parabolic reflector with off-set slotted linear waveguide radiator. The elevation beam was created by the help of the reflection from the ground.
The S-264 entered the service in the airport of London Heathrow in 1954. S-264 was delivered in several foreigen states. Some radar sets remained in service until 1990.
Source:
- Manufacturers data sheet