www.radartutorial.eu www.radartutorial.eu Radar Basics

Global Positioning System (GPS)

Military GPS receiver

Figure 1: Precise Lightweight GPS Receiver used by the German Armed Forces (Bundeswehr)

Figure 2: GPS satellite orbits around the Earth

GPS satellite orbits

Figure 2: GPS satellite orbits around the Earth

GPS (Global Positioning System) is a worldwide satellite navigation system used to determine position, velocity, and precise time. It is also commonly referred to as NAVSTAR GPS (Navigation System with Timing and Ranging). The system has been fully operational since the mid-1990s and has continuously evolved since then. GPS transmits several different navigation signals, the best known being the C/A code for civilian users and the P(Y) code for authorized military users.

The GPS constellation consists of at least 24 operational satellites distributed among six orbital planes. Their orbits are inclined by approximately 55° relative to the equator at an altitude of about 20,200 km (12,550 miles). Each satellite completes one orbit in approximately 12 hours. This geometry ensures that signals from at least four satellites are available almost anywhere on Earth at any time, providing sufficient information for accurate positioning and time synchronization.

Each satellite continuously broadcasts its unique identification, precise orbital data, and a timing signal generated by an onboard atomic clock. A GPS receiver compares the transmission time with the reception time and determines the distance to each satellite from the signal propagation delay. By combining measurements from at least four satellites, the receiver can calculate its three-dimensional position while simultaneously correcting the offset of its internal clock.

Figure 3: Block diagram of a GPS receiver

Figure 3: Block diagram of a GPS receiver

Block diagram of a GPS receiver

Figure 3: Block diagram of a GPS receiver

C/A Code

The C/A (Coarse/Acquisition) code is transmitted on the L1 carrier frequency of 1575.42 MHz. It consists of a unique pseudo-random noise (PRN) sequence used to spread the transmitted signal. Every GPS satellite transmits its own PRN code, enabling receivers to distinguish between signals from multiple satellites operating on the same carrier frequency.

Example of a C/A code sequence

Figure 4: Portion of the C/A code transmitted by a GPS satellite

The same PRN sequence is generated within the receiver. By correlating the received signal with the locally generated code, the receiver measures the signal delay and calculates the distance to the satellite. In addition, each satellite transmits a navigation message containing orbital parameters, clock corrections, and other information required for accurate position determination.

P(Y) Code

Civilian users have access only to the Standard Positioning Service (SPS). The encrypted military P(Y) code is reserved for authorized users and provides improved resistance against interference and signal spoofing. The German Armed Forces use this service under international agreements.

Precise Lightweight GPS Receiver in the ROLAND surface-to-air missile system

Figure 5: Precise Lightweight GPS Receiver in the ROLAND air defense missile system

The P(Y) code is transmitted on the L2 carrier frequency of 1227.60 MHz. Its pseudo-random sequence is significantly longer and has a much higher chip rate than the C/A code, allowing more precise measurements of signal propagation time. Together with compatible military receivers, it provides greater positioning accuracy, robustness, and operational reliability.