www.radartutorial.eu www.radartutorial.eu Radar Basics

Spectrum Analyzer

Figure 1: R&S FPC 1500 Spectrum analyzer
(Courtesy of Rohde & Schwarz)

Figure 1: R&S FPC 1500 Spectrum analyzer
(Courtesy of Rohde & Schwarz)

Spectrum Analyzer

The spectrum analyzer is used to examine the frequency spectrum of radar transmissions, local oscillators, test sets, and any other equipment operating within its testable frequency range. With experience, you will be able to determine definite areas of malfunctioning components within equipment. Successful spectrum analysis depends on the proper operation of a spectrum analyzer and your ability to correctly interpret the displayed frequencies.

1/PW
1/PRT
PW
PRT
transmitting
frequency
cutting frequency
of the band filter
Spectrum analyzer
Oscilloscope

Figure 2: Comparison of a spectrum analyzer and an oscilloscope display

1/PW
1/PRT
PW
PRT
transmitting
frequency
cutting frequency
of the band filter
Spectrum analyzer
Oscilloscope

Figure 2: Comparison of a spectrum analyzer and an oscilloscope display

Radar transmitting impulses can better measured with a spectrumanalyzer than with an oscilloscope. The nominal Tx-frequency, the bandwidth, pulse with (PW) and pulse repetition time (PRT) can be detected from the announced signal. (The upper half of the signal is shown in the graphic only.) Often the oscilloscope cannot display even the high frequency, therefore only a demodulated videosignal is shown here.