D2P
Description of the radar set, tactical-technical characteristics
Figure 1: D2P
| Specifications | |
|---|---|
| frequency: | 13,9 GHz
(Ku band) |
| pulse repetition time (PRT): | |
| pulse repetition frequency (PRF): | 1 … 1.75 kHz |
| pulsewidth (τ): | 3.072, 1.536, 0.768, 0.384 µs |
| receiving time: | |
| dead time: | |
| peak power: | 5 W |
| average power: | |
| instrumented range: | 10 km |
| range resolution: | 42 m |
| accuracy: | |
| beamwidth: | |
| hits per scan: | |
| antenna rotation: | |
| MTBCF: | |
| MTTR: | |
D2P
D2P (Dual-Doppler Precision) is operating in the Ku band (IEEE designation) or in the J band (NATO designation) radar altimeter developed in 1998 at the Johns Hopkins University Applied Physics Laboratory (JHU/APL). The goal of this project is to demonstrate two improvements to satellite radar altimetry and to mitigate the risks to a future flight program that would use this improved altimeter. It was deployed in the bomb bay of a Lockheed P-3 Orion.
The radar transmits with intrapulse linear frequency modulation. Each of the two antennas has the following dimensions: a width (cross-track) of 15 cm and a length (along-track) of 30 cm. The half-power beam width is 8° in cross-track and 4° in along-track.
All Doppler and phase monopulse processing was done in the laboratory and not on the aircraft. The delay/Doppler principle requires a Fourier transform to be performed on a group of samples from pulse to pulse, followed by an earth curvature correction and another Fourier transform. Additional calculations were needed to account for variations in flight altitude, terrain slope, and vertical velocity. These steps ensure that the radar system timing is set correctly and that the averaged waveforms across all Doppler bins are spatially correctly aligned from one pulse to the next.
The first two test flights of the D2P instrument took place on March 30 and April 3, 2000.