www.radartutorial.eu www.radartutorial.eu Radar Basics

Rat-race coupler

1
2
3
4

Figure 1: Simple rat-race coupler with four ports

1
2
3
4

Figure 1: Simple rat-race coupler with four ports

Rat-race coupler

The rat-race coupler or 180 degree hybrid junction is a four-port network and may be used to a simple monopulse network. In case of transmitting the input is applied to port 1, it will be equally split into two components without phase difference at ports 2 and 3, and port 4 will be isolated. Ports 2 and 3 are connected with the left and right antenna group. In case of receiving the ports 2 and 3 are used as input ports. Port 1 provides the sum signal Σ, and port 4 provides the difference signal Δ. The 180 degrees Hybrid Coupler can likewise be used in the opposite manner. If we have both the sum and difference of two signals available, we can use this device to separate the signals into their separate components!

Figure 2: Dimensions of the rat-race coupler

Figure 2: Dimensions of the rat-race coupler

The 180 degree hybrid junction can be used to as network with a 180 degree phase shift between the two output ports also. If the input is applied to port 4, it will be equally split into two components with a 180 degree phase difference at ports 2 and 3, and port 1 will be isolated. The scattering matrix for the ideal 3dB 180 degree hybrid thus has the following form:

Figure 3: Rat-race coupler implemented as a microstrip circuit, used here to match the differential output of a 24 GHz radar chip to a patch antenna.

Figure 3: Rat-race coupler implemented as a microstrip circuit, used here to match the differential output of a 24 GHz radar chip to a patch antenna.

The matrix is unitary and symmetric. Hence, this coupler is likewise a −3dB coupler – the power into a given port (with all other ports matched) is equally divided between two of the three output ports.

180° hybrid rat-race couplers can be implemented as a microstrip network or as a waveguide section. The ring-shaped inner conductor must have an impedance matched to the impedance of the feed lines Z0 by a factor of √2. This can be clearly seen in Figure 3: the ring-shaped inner conductor has a narrower conductor width.