www.radartutorial.eu www.radartutorial.eu Radar Basics

Parity Information (PI)

Parity Information (PI) is used both on uplink and downlink to check the quality of the decoded data. The parity field are 24 bits calculated on the sending end, used to detect errors in data transmission between interrogator and transponder. It uses a modified cyclic redundancy code based on the polynomial:

G(x) = x24 + x23 + x22 + x21 + x20 + x19 + x18 + x17 +
+ x16 + x15 + x14 + x13 + x12 + x10 + x3 + 1
(1)

Depending on the message format, the calculated parity information is combined with the individual 24-bit aircraft address (Address/Parity, AP) or with an interrogator identifier (Parity/Interrogator Identifier, PI). In certain transmissions, such as ADS-B, the parity information is transmitted without an additional identifier. In all cases, it occupies the final 24 bits of the message. At the receiver, the parity information is calculated again and compared with the transmitted check bits. If the results match, no transmission error detectable by this checking procedure has been found.

The polynomial G(x) enables the detection of transmission errors and, under certain conditions, also their correction. On the uplink, however, only error detection is used to keep the transponder circuitry as simple as possible. On the downlink, the ground station can additionally perform error correction.

Sources: