www.radartutorial.eu www.radartutorial.eu Radar Basics

Training questions antenna technology

Please try to answer some of the more frequently asked training questions in written form.
In answering these questions perhaps you could print out this page.

Please respond to these specific questions about radar basics. The reasonable time to frame the answers is about 30 minutes. You can use a pocket calculator, but the chosen here numerical examples are optimized to perform with mental arithmetic.

  1. If the top radiator of a stacked beam cosecant2 parabolic antenna is defective, will this result in

      high-flying targets being detected less well, or
      low-flying targets being detected less well?

     

  2. A linear array of a phased array antenna consists of 44 rows, each with 36 radiator elements. How many controlled phase shifters are required for this antenna:

      36 phase shifters,
      44 phase shifters, or
      1584 phase shifters?

     

  3. With a monopulse antenna, a very large target amplitude is measured in the sum channel for a target. However, no echo can be observed for this target in the difference channel. This can mean:

      the off-boresight angle is zero degrees,
      the target is located exactly in the center of the antenna pattern,
      the sum channel is defective or overdriven.

     

  4. During a maintenance operation, the antenna feed lines for the difference channels ΔAz (delta azimuth) and ΔEl (delta elevation) were accidentally swapped on a monopulse antenna. How does this affect the radar?

      The range of the radar set decreases
          because the transmission power is distributed incorrectly (inverse phase).
      This error only affects reception,
          as these signals are only formed after the monopulse duplexer on the receive path.